AntiMercure® Systems for Mercury Removal from Water


Pre-Engineered, Skid-Mounted AntiMercure® Systems are now available in 3 sizes, based on the AntiMercure® Process for removing mercury from water, proven in:

• Produced Water from Oil/Gas Production, containing glycols
• Oil Refinery Waste Water
• Brine from Mercury-Cell Chlorine Plants
• FGD wastewater
• Ground Water & Wash Waters

FEATURES

BENEFITS

3 Standard Models

• 125 gpm (30 m3/h) (4,300 bpsd)
• 250 gpm (60 m3/h) (8,600 bpsd)
• 800 gpm (180 m3/h) (28,000 bpsd)

Skid Mounted

Reliable Valves, Fittings, & Bed Supports allow Faster Drawing Approval Time

 Standardized, Industry-Approved Parts

Reliable Valves, Fittings, & Bed Supports

 Fits Inside Standard Shipping Containers

Lower Freight Cost for Ocean-Shipping

 MERSORB® LW 1.5mm (or 1.0mm) mercury adsorbent pellets

• Proven 99% Removal of mercury
• No Backwashing Required
• Low Pressure Drop
• Removes all soluble forms of mercury:
(Elemental) (Ionic) (Organo-mercury)
• Easy Loading & Removal of media

 Pre-Filters

Minimize TSS & Particulate Hg

 2 Adsorption Vessels, Horizontal with Lead-Guard Operation and Johnson-Screen Bed Supports

• Continuous Operation, even during change-out of media easy clean-out of media
• Regulators favor Lead-Guard systems

Pre-Engineered Systems Available in a Wide Range of Metallurgy

• 8-12 Week Fabrication Time
• Can Handle wide range of water operating conditions:
pH, Temperature, Salt Content



CAUTION:
Wet activated carbon removes oxygen from air. Thus, an asphyxiation hazard exists inside enclosed spaces containing activated carbon. Use appropriate safety precautions when entering vessels or other enclosed spaces containing activated carbon.
MERSORB® mercury adsorbent is a trademark of Nucon International, Inc. (NUCON®) for impregnated activated carbons used to remove mercury from gases and liquids. Information presented herein is believed to be accurate and reliable but does not provide any guarantee or warrantee by NUCON® or by Selective Adsorption Associates, Inc.
AntiMercure® is a Registered Trademark of Selective Adsorption Associates, Inc. for its Process for removing mercury from water. AntiMercure® is a Trademark of Selective Adsorption Associates, Inc. for its Systems for removing mercury from water. All Rights Reserved.




Contact Us

ADDRESS
41 University Drive – Suite 400,
Newtown, PA 18940, USA
PHONE
+1 215 702 0323
E-MAIL
sales@selectiveadsorption.com